NEW ITEMS   

 

 


See the Koger Company website, makers of the Koger Sunshade, and the Koger Wheel Chock   Improved Chocks 1.jpg (44934 bytes)

 

 ***NEW***  CRAFTLINE TOOL CHEST

CTB-6BX - TOOL BOX HIGH GLOSS RED - $141.00

WWR-4 - Washer Wrench Set of 4 -   $43.00         

    wawrench2.gif (48572 bytes)

Complete set consists
of 4 wrenches with
8 different sizes

  • Wrenches are made of 301 full hard stainless steel AMS 5519
  Wrenches will not rust and will always maintain their rigidity and tension.
  • Precision cut
  Washers snap into position and are held firmly.
  • Convenient pouch
  Helps organize wrenches in one location.
  • Wrenches are 0.042 thick
  Wrench thickness is less than most washers, allowing easier insertion without obstruction.

Over 90% of all washers on an aircraft will fit in these wrenches!

 


HM12 - Hingemate Bolt Insertion Tool -   $29.00         SEE IT IN MOTION! 12min download @ 33K

  • Works for elevator, rudder, and aileron hinge pin insertion as well as other awkward applications.
  • 3/16" bolt size and 1/4" bolt size on opposite ends of tool.
  • Made in Australia.

RLG11 - RIVET LENGTH GAUGE - $6.50            RLG11.jpg (6567 bytes)
  • Gauge measures -3,-4,-5,&-6 rivets.
  • Used to check for proper length of rivets BEFORE setting.
  • Eliminates guessing if your rivets are properly set.
  • Works for both universal head and flush rivets. Precision machined to size from 2024 aluminum.
  • Rivets sizes permanently stamped. Gold anodized finish. Instructions included.

RLG4 - SHOP HEAD RIVET GAUGE SET - $15.00            RLG4.jpg (13557 bytes)
  • Set of four gauges measures -3,-4,-5,&-6 rivets.
  • Each gauge measures minimum height and diameter of shop heads.
  • Eliminates guessing if your rivets are properly set.
  • Works for both universal head and flush rivets. Precision machined to size from 2024 aluminum.
  • Rivets sizes permanently stamped. Gold anodized finish. Instructions included.


NPJ4 - PLATE NUT DRILL JIG #4 SCREW -   $45.00           npj4.JPG (38384 bytes)

  • Perfect for wingtips!
  • Designed for accurate drilling of rivet holes for K1000 & K1100 plate nuts.
  • Flexible handle to provide hand clearance when jig is in use.
  • First drill clearance hole for the screw, insert tool in hole and drill first rivet.
  • Flip tool over, insert both pilots and drill the final hole.

AMP WIRE TERMINALS